Bowers-group Sylvac Z Cal Height Gauges Manual de usuario descargar pdf (Pagina 10)

Remote control of the Z_CAL :

The instrument functions are controlled externally by an ASCII code corresponding to the 3

first letters of the function. Spaces are removed. The message may be in upper or lower case.

The question mark ? implies an instrument response.

? or PRI (PRInt) requests displayed value

CLE (CLEar) reinitialises the maximum / minimum memories

EXT0 external contact = data transmission

EXT1 external contact = display preset

EXT2 external contact = normal mode ↔ diameter mode

EXT3 external contact = reference mode 1 ↔ reference mode 2

EXT? asks for current function of external contact

(EXTernal contact)

EXTB... same as above, but for Print key functions

ID? (Identification) Z_CAL replies : SYLVAC Z_CAL

IN (Inch) display unit

MM (MilliMeter) display unit

KEY0 (KEYboard) keyboard locked

KEY1 keyboard unlocked

AXI (AXIs) centerline mode

DIA (DIAmeter) diameter mode

DEL (DELta) maximum - minimum difference mode

NOR (NORmal) normal mode

MAX (MAXimum) maximum mode

MIN (MINimum) minimum mode

MOD? (MODe) interrogation of the measuring mode : NOR,DIA,AXI,MIN,MAX,DEL

POS + number the instrument positions itself to the value transmitted. If an obstacle

inhibits movement, positionning is given up.

PRE (PREset) displays the preset value

PRE + number memorises a new preset value

PRE? interrogates the memorised preset value

REF1 reference 1

REF2 reference 2

RES2 (RESolution) 0.001 mm - 0.00005 in resolution

RES3 0.01 mm - 0.0005 in resolution

SET? (SETting) interrogation of general parameters :

MM/IN RES2/3 REF1/2 KEY0/1 B0/1. B0 = battery recharging.

UNI? (UNIt) measuring unit : MM or IN

UNI1 mm/inch conversion unlocked

UNI0 mm/inch conversion locked

VER? (VERsion) instrument program version and date

1 2 ... 5 6 7 8 9 10 11 12 13

Sin comentarios

Bowers-group Sylvac Z Cal Height Gauges Manual de usuario Pagina 10